euro truck simulator 2 mods not showing up

EURO TRUCK SIMULATOR 2 MODS NOT SHOWING UP ACTIVATOR
EURO TRUCK SIMULATOR 2 MODS NOT SHOWING UP FULL

But now if u go back in-game click the Y button, you’ll barely see the headlights flash because they turn off before they even the chance to fully light up.To turn off high beam, again hold the Y button for same duration. What this does is that if you simply click the Y button on controller, you’ll flash the headlights, but if u hold them for 0.150s (you can change it) the high-beam will turn on.

EURO TRUCK SIMULATOR 2 MODS NOT SHOWING UP ACTIVATOR

Now, click on ADD ACTIVATOR and under Activation type select long press.Ĭlick on the binding and select ‘K’ key on keyboard.This means that when we u simply click the Y button, ‘J’ on keyboard will be activated for that moment, which is the light horn/flasher. Under the regular press, click on the binding and select ‘J’ key on the keyboard.At the bottom right, you’ll see SHOW ACTIVATORS. Click on the “Y” key in the menu, you’ll see the picture of keyboard and other buttons.~ If you were following the guide till now, you might’ve notice there are 2 functions assigned to “Y” key of the controller in the table above.

EURO TRUCK SIMULATOR 2 MODS NOT SHOWING UP FULL

Now, you can turn smoothly on the highways with low inputs as well as sharply in tight-slow corners with full left stick movement. – reduce the slider such that the value is approximately 0.07.Ĭongratulations if you’ve made it this far. – click on Linear, scroll down and select Custom Curve We want this to be as smooth as possible because we’re using the wheel subtype in-game. This is responsible for how the truck turns.

At the top left, you’ll see Stick Response Curve which should be at linear by default.

Go to Additional Settings (bottom right).

Now click on the bottom left rectangle representing the left stick.

We will refer to this page as gamepad settings.

Do NOT use those settings, instead click on the templates (left side) and select gamepad.

You will most likely come across the recommended settings like this.

Click on controller configuration at the top right.

Press shift + tab to open the steam overlay.

To maximise the effectiveness and ease of handling with the controller, we need the help steam.

I’d recommend to at least go through to part III for the steering settings, which are the most important imo.

So, if you’re confused about something, you can refer to the videos as well.

I’ve provided a link to youtube clips under each section which do exactly what that section says.

Cons: You control the steering of the truck, the game doesn’t restrict it, no matter the speed.

Pros: You control the steering of the truck, the game doesn’t restrict it, no matter the speed.

Hence, no need to buy a wheel to drive fast into corners anymore and also no need to reach out to the keyboard to press “enter” at tollbooths or uncouple the trailer etc. Also, using the steam controller configuration settings, you can bind almost anything you want to the controller itself.

This guide aims to get rid of all those issues while still maintaining the smooth inputs of steering at high speeds in highways.

Hence, we have to slow down to 5kph to make 90° tight turns or even at roundabouts. The game has an in-built speed sensitivity setting (uneditable) which limits your steering angle based on the speed you’re driving and this value is too high.

ETS 2 was released in 2012 but still we still we only have 2 basic options for driving.

Euro truck simulator 2 mods not showing up